So I'm putting a rs2 gearbox into a urs4. The linkage is different so I have swapped over bits and bobs to get it matched up. My problem is that there is a housing that holds the reverse light switch that is much smaller on the rs2 box than the urs4 and v8 s4 boxes I have. I need to use the larger housing as it has a nipple for the linkage. So on the rs2 box everything seems OK with the larger housing on. But on the urs4 gearbox when I bolt up the rs2 housing I cannot select gears.
So my concern is that the larger housing will allow something to move that shouldn't on the rs2 box. I would also like to use the urs4 box at some point in the future but obviously this smaller housing isn't going to work. Any thoughts or btdt ?
Sent from my GT-N7105 using Tapatalk
So my concern is that the larger housing will allow something to move that shouldn't on the rs2 box. I would also like to use the urs4 box at some point in the future but obviously this smaller housing isn't going to work. Any thoughts or btdt ?
Sent from my GT-N7105 using Tapatalk
Comment