Removing track control rods.

[John.]

While the front subframe is off my CQ, I'm thinking I'll now get around to fitting the new adjusters and TRE's I have. Just looking for someone to confirm that the best way of doing this would be to remove them complete with the bracket that attaches to the rack, I started to slacken one of the bracket bolts as can be seen in this picture......then I started to think-wonder if this is the best way of doing this?
Anyone have any advice?



View from below.
Bled/changed the clutch fluid as well, what an easy job without the subframe in the way!!
John.

[UrS4boy]

These help?





http://audi.7zap.com/en/rdw/audi+cou...oq/1992-141/4/

[Error404]

Yes remove the bracket off the rack piston, pop the ball joints and then you can withdraw both tie rods and bracket through the hole in the inner wing

[John.]

Yes remove the bracket off the rack piston, pop the ball joints and then you can withdraw both tie rods and bracket through the hole in the inner wing

Cheers.