I've replaced the hydraulic servo with a (supposedly good) used one, after topping up the reservoir with some green fluid I started the engine and worked the steering from lock to lock.....all good with the PAS.
But the brake warning symbol shows if I pump the brake. Do I need to bleed fluid from both pipes going to the servo......is this done in a similar way to bleeding the brakes, do I have someone press the pedal while pipe's are loosened??
.....anyone?
Thanks in advance.
But the brake warning symbol shows if I pump the brake. Do I need to bleed fluid from both pipes going to the servo......is this done in a similar way to bleeding the brakes, do I have someone press the pedal while pipe's are loosened??
.....anyone?
Thanks in advance.
Comment