I scored this set of Recaro seats at a local 'you pull' style junkyard. The price was too cheap to pass on so I brought them home, I did a little bit of playing around and it looks like it might be quite simple to fit these in the back of my b4 sedan.
Here is the rear lowers, the width is perfect and even lines up nicely with the factory uppers:
Rear upper width is extremely close as well, overall width is within 1/4th of an inch:
(obviously that photo just shows it fitting width wise, i didn't feel like removing the rear uppers at the moment)
Fronts should be quite simple. The B6 seats have integrated rails and just bolt down in the 4 corners. I figure i'll probably take a stock set of seats, chop everything off them and keep the mounting points and attach some bar stock with some mounting points for the b6 seats. That should keep it completely reversible.
Here is the rear lowers, the width is perfect and even lines up nicely with the factory uppers:
Rear upper width is extremely close as well, overall width is within 1/4th of an inch:
(obviously that photo just shows it fitting width wise, i didn't feel like removing the rear uppers at the moment)
Fronts should be quite simple. The B6 seats have integrated rails and just bolt down in the 4 corners. I figure i'll probably take a stock set of seats, chop everything off them and keep the mounting points and attach some bar stock with some mounting points for the b6 seats. That should keep it completely reversible.
Comment