Tweet
Finally got my breather system upgraded.
Works a treat. Thanks Andy Casey (Rusty).
Sent from my Nexus 5 using Tapatalk
Works a treat. Thanks Andy Casey (Rusty).
Sent from my Nexus 5 using Tapatalk
-
RS2+ (now sold...) -
That catch tank looks very OE, nice install
1996 S2 ABY Silver -
More pics
Sent from my Nexus 5 using TapatalkRS2+ (now sold...)Comment
-
Very tidy. Any more pics?
Panthero Coupé quattro 20vt
Indigo ABY coupé
Imola B6 S4 AvantComment
-
Sump return
Sent from my Nexus 5 using TapatalkRS2+ (now sold...)Comment
-
Different angle
Sent from my Nexus 5 using TapatalkRS2+ (now sold...)Comment
-
Looks very OE indeed, nice!
But, and this may be a daft question, is it wise to let it drain back to the sump on the lowest point where there is max volume of oil? Will it actually be able to drain back that way?Comment
-
So the contents of your sump and the life of your engine are in the hands of a single jubilee clip?
Comment
-
Do not like the look of the return being so low when you open the valve its not going to drain down, I welded one in above oil the level. I think that's the way to go Also so found it necessary to fit a no return valve
Last edited by jade; 18 April 2014, 18:44.RS 2 580HPComment
-
Having a return above the oil level is incorrect and will not work on the breather system as it will just act as another feed when the system is under pressure.
The Fumoto valve is the only bolt on option. If you remove the sump, then you can weld on a proper return but that's much more involved.Cheers'en, AndyC
1994 ABY Coupe - Projekt AlpinweissComment
-
That,s why I have a non return valve fitted seems to work fineOriginally posted by Rusty View PostRS 2 580HPComment
-
Tap the end of the Fumoto and use an AN fitting, like Doug did back in the day.Comment
-
That's another way to do it.Originally posted by martinjs View Post
You could also weld AN to drilled OEM sump plug etc.
High Torque hose clip and fluro silicon hose is good enough.RS2+ (now sold...)Comment
-
Comment