new mesh and shinny bits...

[pixsaudisex2]

still aint got the hang of this photo attachment thingy

like the grill mesh let me know,,

[pixsaudisex2]

and under the bonnet

with my new few shinny bits under there 22222222

[slim]

mmmmm nice mind.

[Jas11n]

Very nice,
I spy some of of Mark's hoses under there
How did you do the mesh grille then?

Jas

[rotoryboy]

Looking Good Matey

[pixsaudisex2]

so i take it it would be you i brought my hoses of then ..
had a feeling it would be some one on here .



an in reply to the mesh i went at it with wire cutters for a bit and then well the good old air cutter imagine you might do it with a dremel as i used one occasionaly,

an then i cut a slice all the way from side to side an then slid in the old halfords mesh wasnt to sure if i liked it but every one i ask just points out the fact me bottom grills dont line up but hey they were like that when i had the car .
kinda keeps the factory feel been able to remove them so easy its just a bummer cutting up your grill.. because if it goes bad but if it goes good

[jon_91_s2]

Like the grill dude.

Been thinking about doing somethig like that for a while now but there is always something else that needs doing.

Cheers

[4WheelDrifter]

Mmmm... Nice shiney bits. You from the Midlands?

[pixsaudisex2]

yip i certainly would be from the midlands

[4WheelDrifter]

Aha! Thought so. I could tell by your accent.

[ThatGUY]

Love the mesh look

[pixsaudisex2]

did you all spot the audi chrome top strut covers
ok the honda ss50 side engine covers i found in the shed that looked pretty clean
and well they glued on preety well using some of that NO MORE CAR PARTS FLYING OF DOWN THE ROAD GLUE,

so what would all your guesses be for the power out put on it
it goes up to about 1 bar
a chip an turbo of dialynx a power flow exshaust no cat air filter the way ive got it though i think its costing me air filter that is


i used to own a golf gti good car few mods then i got a omega ex police 3 litre 24v 34 000 miles on the clock an well that felt fast an then a year ago or two i brought the might s2 id like to say that was a lot quicker than the omega by a long way ( well due to the auto box suppose the old motor way speeds would be close for a while..

well what i was on about i was hopin to be running about 300 bhp do you think this would be possible with these mods or miles of
trying to save the red face with guessing at roalling road,,



an well i would say massive brakes but gee ive seen the size of some off yours
but hey they say its not the size that matters dont they

[pixsaudisex2]

just thought id add i put an inlet manifold on ebay today for an aby if any one was intrested ,,,

[auditude]

just thought id add i put an inlet manifold on ebay today for an aby if any one was intrested ,,,

Item :4554423104

[Bibby]

Pix, are you the chap who was at the Malvern show with the black avant?