Group buy: Adapter for fuel pressure sensor with oel connecter

[s0_big]

Since I have Maxxecu I will connect this sensor to my Ecu.

http://www.maxxtuning.eu/products/engine-control-and-electronics/sensors/pressure/pressure-sensors-9bar-0-5v-oil-or-water-or-gas-or-ethanol

[Dynasty]

Great idea, I want to order two of these adapters.

Regards Eivind.

[Jonas_R]

Zeitronix Sells a 10 bar fuel pressure sensor that I'm planning to use.

I'm not planning to include sensor, since people use different logging equipment, ECU etc.

[Nuno_Cristiano]

I have interest on it but to be perfect is better we find a fuel pressure sensor and put on adapter. Will be perfect to send information to standalone ecu about pressure in fuel system.

[M_GORDON]

Hi, I'm interested too

[Jonas_R]

Just a quick update. I have quotes out at two vendors.

I have asked for prices in Alu and stainless steel.

I'm dropping the brass idea.

[Jonas_R]

1x Jonas_R
1(2)x s0_big
1x newsh

[newsh]

Yeah, go on then, add newsh to the list [emoji106]

[s0_big]

1x Jomas_R
1(2)x s0_big

Nobody else that are interested in this nice part? ☺

[Jonas_R]

1x Jomas_R
1(2)x s0_big

[s0_big]

I want one, two if it helps to get it done
Really appreciate your work Jonas

[Jonas_R]

So I'm looking to get this little adapter made.



It will be male M14x1,5 with flared end and female M14x1,5 designed for the Audi connector.

It will then have a threaded 1/8" npt hole for sensor etc. This thread in the hole can be changed to something else.

It based on the German DIN standards for a Bördel F connector which Audi uses for our cars.

Plan is to make it in Alu and stainless steel (if it won't be to expensive) and it will be fitted like this.




I trying to get a quote and I would like to have 10-20 made to get the price down.

I will update when I get some prices.

Update 15-06-2017
Prototype ordered 15-06-2017, should hopefully have within 1-2 weeks.

Price Update 21-07-2017
Price in stainless steel minimum of 10 units: 45 euro + shipping.

We have dropped the aluminium part.

Hoping to start collecting money in week 30-31 and then start the prototypen in week 32.

Installation instructions:

I install my fitting in the fuel feed line, at the junktion near firewall.

If you have problems getting the sensor to orient the right way, then you can loosen the feed line at the fuel rail and get the fitting and sensor oriented correct and then thigten the feed line afterwards at the fuel rail.

For the fitting itself there is no need for thread sealent.

However the sensor should get some thread sealent or PTFE tape or similar.

Installed on my ABY:
IMG_20180307_202647858.jpg

IMG_20180307_202623692.jpg
IMG_20180307_202645445.jpg