Small Urs6 project!

[Spyform]

Good work man!!!!

[maiks]

Thanks.


And it happened agan



This time I removed the exhaust manifold..
Both flanges were bend...
I think stainless manifold is crap...
But maybe it just bends at the beginning and later does not bend so much..
Weird, lots of people drive with stainless and I haven't heard about a problem like that.



There were not very smooth welding, so I grind it a little, now it seems to be much better.

[Thuppu]

I have been using a "gasket" cut out from 1mm stainless sheet. If the flanges are 100% flat then there would not be any need for a gasket.

[maiks]

I have been using a "gasket" cut out from 1mm stainless sheet. If the flanges are 100% flat then there would not be any need for a gasket.

With what you cut out? cnc?
Sadly the problem was on the bend flanges. At the beginning flanges were flat, but there was more than 1 mm bend... And flames burned gasket out and also turboblanket does not hold flames and has started to burn out
Now it is all flat and I hope it stays flat It's a little funny not to put any gaskets and I already have those, so this time I'll go with gaskets
One guy told that he had cast iron em and even that bend a little, so the bolt broke in to the engine Luckily my bolts are fine


And engine and gearbox mounts arrived also!

[macspring]

Any more details on the gearbox and engine mounts ?

From who, cost, and spec ?

Thanks.

[maiks]

Any more details on the gearbox and engine mounts ?

From who, cost, and spec ?

Thanks.

From- AnLe
Cost- a little over 200 eur
Spec- 70shore urethane

[igor136]

Nice work here. Are you satisfied with bilstein shocks?

[macspring]

From- AnLe

Sorry don't understand this.

Thanks.

[Thuppu]

Sorry don't understand this.

Thanks.

http://www.s2forum.com/forum/showthread.php?t=79243

http://www.s2forum.com/forum/member.php?u=215

[macspring]

Hi Tomas,

Thanks for your time in answering my query so perfectly.

I now remember the thread looking at your link, but didn't note the name of AnLe at the time.

Thanks again, appreciated.

[maiks]

Nice work here. Are you satisfied with bilstein shocks?

Yes, super good

[maiks]

And back together... Not the cheap heat tape, but after warming it exploded to fire
Luckily I had the fire extinguisher in my trunk and nothing serious happened.
Seller told that he had never problems with that
Now I have driven a lot and seems that it won't burn any more

[igor136]

Nice car.I noticed that you put together h & r springs with B6 shocks. Is not better to use B8 to them? Just curious.

[hunker7]

Nice car.I noticed that you put together h & r springs with B6 shocks. Is not better to use B8 to them? Just curious.

B8 is for when you go more that 30mm I think.

[igor136]

H&R is - 40.When the car goes on the hoist, will that be a problem?