i would like to know what u guys think about this mod???????????
i will take a k26 nr 6 hotside and machine it out to fit a k27 wheel and then use a k26 centre housing to keep the water feeding then i will use a k27 backplate and cut the compressor housing to fit a k28 comp wheel.
now i have measure the comp wheel and find the following
exducer between 80 and 83mm
inducer between 50 and 53 mm (my measuring tape is not 100%)
nr at the back of the wheel 3521709
on the exhaust wheel
exducer 75 mm
inducer 65 mm
will it work???????????????will see
i will take a k26 nr 6 hotside and machine it out to fit a k27 wheel and then use a k26 centre housing to keep the water feeding then i will use a k27 backplate and cut the compressor housing to fit a k28 comp wheel.
now i have measure the comp wheel and find the following
exducer between 80 and 83mm
inducer between 50 and 53 mm (my measuring tape is not 100%)
nr at the back of the wheel 3521709
on the exhaust wheel
exducer 75 mm
inducer 65 mm
will it work???????????????will see