~400hp

[Pirvu Eugen]

so what will be the best turbo for 400hp and a lot of down torque?
Sorry for so many questions, but You realy know!
Thank You!
Eugen

[Jamo]

307!R 450 is possible on it. 2871 will spool quicker than the K24 and will make around 400. The reason why it's not a s popular is that it's harder work to get the setup right with this turbo on the I5 engine

[Pirvu Eugen]

Sorry GT 2871! There are so many options!
What do You think?
Thanks

[Pirvu Eugen]

I am looking for 400 420 hp. So the gt3071 will do that and with some impresive torque at low revs? That is what I am looking for.
Thank You!
All the best!
Eugen

[Bram]

GT2871 can do the job as well, if 400 hp is enough for you. It will make some nice boost. If 380 hp is also ok, for you and you want 600Nm boost then take the RS2 turbo, combined with custom mapping. That turbo works just fine.

[Pirvu Eugen]

What about the turbo? Definetly i have to go to GT 3071R, or there are some other turbos for 400 hp with low rev torque?
Thank You!

[Pirvu Eugen]

Glad to hear this because , if i understand right, the AAN is much more reliable and tunable as 3B.
Thank You very much!
You are great!
Eugen

[DJones]

I have an AAN in my ur no speed sender and no problem.

[kwlw]

iirc I don't think it will not let the engine start (cut spark out), but I'm sure someone will correct me

It just there for speed limiter IMO. No real problems with AAN's without this signal.

Sau

[Pirvu Eugen]

Hope not!

[Cullam3n]

iirc I don't think it will not let the engine start (cut spark out), but I'm sure someone will correct me

[Pirvu Eugen]

Hy guys! I saw that the AAN, ABY,ADU ECu's have an input signal from the vehicle speed sensor. Problem is that I have cable speedometer. Is any problem if the ecu will not have this signal?
Thanks!
I have untill now the AAN ecu, 420 cc at 3 bar injectors, 7A cams, an complete 3b engine to dismantle.
I was wondering What turbo should i get for 400-420 hp. I will have an ~50% bigger intercooler, reversed intake manifold, and tubular EM. I am looking for high torque rather big power.
Thanks!

[Pirvu Eugen]

soooooo! you are the oneeee!
thanks!

[LHD_Kid]

Heyyyyyyy it's my job to poke Eugen for going SERIOUS power...........

You'll need some rods.....anybody got a set to sell him, as I want him to hurry up and get it done....

[Pirvu Eugen]

don't push me! i am at the edge of madness already!