Oil breather

[S2central.net]

I have made a new oil breather set up.

With 2.2 bar it is getting some blow by, as you would expect. I was not happy that i was venting it well enough i.e. it all passed down a 13mm pipe at the end of its journey.

In my opinion to small so i have adapted it and fitted the new bottle on the right in the pictures. It may be a bit OTT buts that's me for ya..

Mr Jones - your engine bay is so clean sir. It makes me feel ill...
Nice plumbing idea too by the looks of things.

Paul

[kwlw]

On thinking about this, i recon it because of the holes i cut at the rear of the bonnet.

I cut the holes to allow the heat to pass over the firewall and pass through the bonnet vents. On a standard car it is a rubbish design the heat has nowhere to go. I guess the smell passes out at the same time.

I personally don't think that your idea is very good. On standard car - heat must go beneath the car or through the vents in the first third/middle of the hood. Area where hood vents are located is high air pressure area, and there air is getting in, not out. So you are redirecting heat from the engine to your heater, and inside the car. This means breathing fumes, especially through center vents.

Here is ilustration what I'm talking about:


Is it so cold in the mornings to go such sacrifice? .

Sau

[Pirvu Eugen]

super idea! never thought at this!
good thing!
All the best!
Eugen

[DJones]

Its a good point!! but it seams ok so far..

On thinking about this, i recon it because of the holes i cut at the rear of the bonnet.

I cut the holes to allow the heat to pass over the firewall and pass through the bonnet vents. On a standard car it is a rubbish design the heat has nowhere to go. I guess the smell passes out at the same time.

[s2driveruk]

glad you had a chance to complete it yesterday Pipework looks very tidy considering your evaluation of your tig work yesterday

[DJones]

Nice job!
You have burned oil smell in the cabin?
Iff not how you have done that?
Supper!
Eugen

Its a good point!! but it seams ok so far..

[DJones]

Darren, have you got an oil return from the catchcan to the sump?

Yes the first bottle goes back to the sump. the second bottle just has a drain valve for condensation...

[spink]

Darren, have you got an oil return from the catchcan to the sump?

[Pirvu Eugen]

Nice job!
You have burned oil smell in the cabin?
Iff not how you have done that?
Supper!
Eugen

[Fat Audi 80]

You're not messing about with that car are you? Very nice

[DJones]

Another..

[DJones]

I have made a new oil breather set up.

With 2.2 bar it is getting some blow by, as you would expect. I was not happy that i was venting it well enough i.e. it all passed down a 13mm pipe at the end of its journey.

In my opinion to small so i have adapted it and fitted the new bottle on the right in the pictures. It may be a bit OTT buts that's me for ya..