Found an engine and i think to buy it.
Someone put 2.3.2 motronic on it?Will need fly with pin for the crank position sensor,cps signal will be from distribuitor.What about the rest:
1.iat
2.tps(i saw that mc has one,is the same thing?)
3.knock sensor(it is mc1 so will be abble to mount the other one on the block?)
4.Fuel rail
5.What turbo has the mc?k24 7000 will fit there?
And the most concerning question:how will act a 10v with a 20v motronic?Will it run with a standars soft or will need a custom one?
How much$for this engine?Know nothing abuot it(turbo good/bad,EM cracks,worn block,rings,bearings,etc)Off coure seller said:"it was perfect when i got it out"
I have 2 20v so spares for them from mc will be fiew,block only and almost..
Regards,
Found this: http://www.youtube.com/watch?v=TQHqYzbvkcc
How funny the coils sit there
Someone put 2.3.2 motronic on it?Will need fly with pin for the crank position sensor,cps signal will be from distribuitor.What about the rest:
1.iat
2.tps(i saw that mc has one,is the same thing?)
3.knock sensor(it is mc1 so will be abble to mount the other one on the block?)
4.Fuel rail
5.What turbo has the mc?k24 7000 will fit there?
And the most concerning question:how will act a 10v with a 20v motronic?Will it run with a standars soft or will need a custom one?
How much$for this engine?Know nothing abuot it(turbo good/bad,EM cracks,worn block,rings,bearings,etc)Off coure seller said:"it was perfect when i got it out"
I have 2 20v so spares for them from mc will be fiew,block only and almost..
Regards,
Found this: http://www.youtube.com/watch?v=TQHqYzbvkcc
How funny the coils sit there