I'm putting together my fuel lines.
-8an for the feed and -6an for the return.
My question is once I get to the tank lid
there is a banjo up top for the feed and
just a barb for the return. Anyone know
how I could make it %100 braided steel
from front to back? I need to know what
size the banjo on the feed side of the lid is
to find an banjo>-an fitting and for the return
I'm think I could cut out that steel barb
on the lid and thread in a -an fitting/ bung
or whatever completely into the plastic tank lid.
Any help or insight is greatly appreciated.
P.S. I was also thinking of a way to make the
turbo coolant return line to the block steel
baided instead of rubber line on the freeze plug
nipple.
-8an for the feed and -6an for the return.
My question is once I get to the tank lid
there is a banjo up top for the feed and
just a barb for the return. Anyone know
how I could make it %100 braided steel
from front to back? I need to know what
size the banjo on the feed side of the lid is
to find an banjo>-an fitting and for the return
I'm think I could cut out that steel barb
on the lid and thread in a -an fitting/ bung
or whatever completely into the plastic tank lid.
Any help or insight is greatly appreciated.
P.S. I was also thinking of a way to make the
turbo coolant return line to the block steel
baided instead of rubber line on the freeze plug
nipple.