Audi 100 C4 and URS4 differences?

[Majorcina]

If ur car is fwd u dont have a tunel for diferencial and drive shaft,it can be done but is very hard and u need to cut the floor,its maybe bether to find a body with quatro then to do that

[Matte90]

What about A100 non quattro and S4 quattro? I have a A100 with only 2 owners and both in our family and i want to convert it into a S4 with the engine and drivetrain. Is there any diffrences between these cars if you see it that way? I mean under the floor..

EDIT: I just saw this thread was under "exterior" but i found it trough google so i apologize.

[UrS4boy]

I wonder if the URS4 front fender/wings and bumper fit on the B4 coupe edited

Nope.

[Majorcina]

Yeah thats what i toth to Dave

[UrS4boy]

as far i know audi c4 coupe dont exist

C4 = sedan or avant, that's it. Not even a factory C4 coupe prototype AFAIK.

[Majorcina]

as far i know audi c4 coupe dont exist

[UrS4boy]

I wonder if the URS4 front fender/wings and bumper fit on the C4 coupe

Porsche C4? No.

Abt C5? No.

What mischief are you up to?

[pinotattt]

I wonder if the URS4 front fender/wings and bumper fit on the B4 coupe

edited

[Zoig]

I just saw in Etka that there is some "wheel cover" for Audi 100 C4 bumper.



Does anybody have picture of C4 and S4 bumpers so I can see is this cover only difference or there is something else?

This cover is wheel arch extension, most probably for protection. Even if the front bumper extension is wide enough to cover the arch gap on wide fenders the side profile is too different to look decent.

Basically the same as on prj's old UrS6:

http://www.s2forum.com/forum/showthread.php?t=54553

[shone190]

That's the answer I was looking for

OK, I'll consider this because I need to find S4 bumper for this URS4 Avant if I buy it

[UrS4boy]

I just saw in Etka that there is some "wheel cover" for Audi 100 C4 bumper. Does anybody have picture of C4 and S4 bumpers so I can see is this cover only difference or there is something else?

The UrS4 bumper does NOT have that extension. The bumper flare needed to match up with the UrS4 front fender/wing is an integral part of the bumper, not an add-on piece. That said, *IF* 4A0807257 was still available (which I highly doubt), it would be interesting to see if it did convert a C4 Audi 100 bumper to UrS4 duty.

Note 1: "B, I and S" are Belgium, Italy and Sweden (??)
Note 2: Look higher on that same source at Item 1. 4A0807103AL is for the C4 100. 4A0807103B is for the UrS4 (either AAN or V8).

Here is a photo of Euro bumpers (front and rear) on an award winning UrS4

[shone190]

I just saw in Etka that there is some "wheel cover" for Audi 100 C4 bumper.



Does anybody have picture of C4 and S4 bumpers so I can see is this cover only difference or there is something else?

[UrS4boy]

I like the one without spoiler most

Okay, we have just experienced a language malfunction. You have been talking about the hatch on the avant. I have been talking about the trunk/boot lid on the sedan/saloon/limosine.

I agree that there were spoiler and no-spoiler version of the avant hatches. The avant hatches without the spoiler are completely smooth on top. The avant hatches with the spoiler have indents for the feet of the spoiler to sit down into.

[pasbogdan]

I like the one without spoiler most

[UrS4boy]

Not the same between a6/s6,they will fit but the s6 has a deeper lower section

"Same story for the C4 A6/UrS6" = the rear bumpers are the same but the front bumpers are different, primarily because of the flared arches on the S6 front fenders (wings). The bumper depth is incidental to the flaring.

C4 Audi 100 bumpers will fit on a C4 Audi A6 and vice versa.

C4 Audi UrS4 bumpers will fit on a C4 Audi UrS6 and vice versa.

And then there is the difference between the Euro bumpers and the NAmerican bumpers but we need not go there.