What clutch are you running for 500-600 bhp

[SteveH]

620Nm on my SRE/sintered and at least two years of abuse. Hard launches with LC set to 1.2Bar and it doesn't slip.

[Rich]

Ok thanks! I will give it a go!

[Rich]

Do i have to buy the pressure plate from Sachs or is the original sufficient ?
Thanks

[s2dk]

its a set you buy

[diesel des]

You need the sre pressure plate and sintered disk. As I say mine has held 720nm in my stroker without issue other than being harsh.

Sent from my Moto G (5) using Tapatalk

[SteveH]

Just stripped my motor down for a rebuild and the sintered SRE still had some life in it. It looked like I'd overheated it on the last track I did when the gearbox went bang. I've dropped it off to have new pucks fitted and the flywheel and pressure plate resurfaced. I recon it's lasted 8K-10K miles.