hi all,
just fitted a new genuine clutch master cylinder to my ABY 6spd.
Bled it through a complete eazibleed resevoir with engine switched off.
Then tried it out when stationary, and had to adjust the screwed bar on the MC to fully out, otherwise the pedal just stays down.
Now, having just taken it for a drive, the clutch feels terrible, does nothing for the first half of travel, its hard to get into gear unless you weld your foot to the bulkhead, and the bite point is really low.
Any ideas
just fitted a new genuine clutch master cylinder to my ABY 6spd.
Bled it through a complete eazibleed resevoir with engine switched off.
Then tried it out when stationary, and had to adjust the screwed bar on the MC to fully out, otherwise the pedal just stays down.
Now, having just taken it for a drive, the clutch feels terrible, does nothing for the first half of travel, its hard to get into gear unless you weld your foot to the bulkhead, and the bite point is really low.
Any ideas