Ok so I have pretty much all the wiring done and can start putting the interior back together but I want to get a few things sorted out before I stuff the dash back in, just in case I have to tear back into the wiring to solve what ever I have going on. The issue is that the car will start up and run but extremely rich like the injectors are running at full cycle! I checked the MAF and it was reading over the voltage of what it should be so I changed it out. The car still does the same thing same readings... I checked all the connections, checked the N75, O2, altitude sensor as well as the FPR they all check out... Then I did a teminal check to make sure all the wires from the ECU to each component have a good circuit which they all do. I am stumped at this point an can only think the ECU has an issue but I don't have one to test to see if it solves my problem. Have any of you ran into this issue of running rich and the MAF reading high voltage when checked between terminals #1 and #3??? Any help would be greatly appreciated.
Announcement
Collapse
No announcement yet.
3B swapped US model 90 running issues
Collapse
X
-
G62 Coolant Temp sensor info and reasons why it is important
Originally posted by Racerguy381 View PostOk so I have pretty much all the wiring done The issue is that the car will start up and run but extremely rich like the injectors are running at full cycle! Any help would be greatly appreciated.
G62 Coolant Temp sensor info and reasons why it is important:
http://forums.quattroworld.com/s4s6/msgs/20985.phtml
RS2'd 93 UrS4 5 spd sedan
94 UrS4 V8 6 spd manual avant
Comment
-
Originally posted by Racerguy381 View PostI changed that out tonight. No differenceRS2'd 93 UrS4 5 spd sedan
94 UrS4 V8 6 spd manual avant
Comment
-
I'll check the circuit between the G62 and the ECU to be sure nothing is wrong with it. This is what it sounds like with the MAF plugged in idling. The voltage at the MAF before running is within range 1.4volts. But running it jumps to 3.4volts which is a full volt higher than where it should be. https://vimeo.com/130980288
Comment
-
G70 Mass Air Flow (MAF) sensor info including cleaning, testing, etc
G70 Mass Air Flow (MAF) sensor info including cleaning, testing, pins out of their sockets, etc:
http://forums.quattroworld.com/s4s6/msgs/20442.phtml
RS2'd 93 UrS4 5 spd sedan
94 UrS4 V8 6 spd manual avant
Comment
-
Any fault codes?
How did you check the FPR and lambda?
How rich? How do you know its rich?
Is this cold start, when driving, when hot?Current-2004 Impreza PPP wagon
Sold-92 3B coupe-RS2+, 996s, konis, rear torsen, forged rods........
Sold ABY-stock
Comment
-
The car is still in the middle of the engine swap. I have it in the garage on blocks so I can't test drive it. And I was able to check the 02 with the multimeter and the FPR with a gauge. I know it's Rich from all the gas fumes in the garage when it's running with the MAF plugged in and and the amount of voltage then it's reading when terminals 1 and three are jumped with a multimeter
Comment
-
Clean the maf connector terminals, both male and female contacts, with 1000 grit wet and dry and coat them with silicon dielectric grease.
Check or replace the white temp sensor on the back of the head.
Comment
-
Is there any chance your ECU has been modified?
Comment
Comment