anybody on here done a s2 audi 80 quattro b4 sedan

[bluequattro]

Good point above Micky.
I'd like to know what to do for 5 stud hubs on fwd cars like my tdi 80 so I can make an s2 limo replica.
Would like spoiler raisers like in previous pictures too.

[irishs2]

FWD 80, project sooty is a good reference for hub conversion

http://www.s2forum.com/forum/showthread.php?t=28022&highlight=hub&page=10

http://www.s2forum.com/forum/showthread.php?t=28022&highlight=hub&page=12

[Error404]

It would be far too much information for one thread!

[micky]

It would be far too much information for one thread!

could condence into a a4 sheet when we have all info

[Vorsprung durch Technik]

i would like to thank everyone who put some good ideas on this thread
maybe some how we could all put what we have done to convert suspentions and what parts works and what dont into a thread so its easy for other people to find info easy instead of trawling threw 100s of different threads to get answers .i am shue i am not the only one with these questions .

I second what you have said wholeheartedly it would be great to have it all in one place. I am doing a 5 stud conversion on my FWD 2.6 Avant,bought the parts just need to find time to actually get dirty and do it.Too many jobs at the moment.

[Mcstiff]

How about swapping the whole rear hub/upright with one from a B5? Same thought for the front, from an S2.

[mdz]

Ok, here ya go:

75mm hub carrier with bearing, B5 A4q rear hub, ~2mm spacer between hub carrier and caliper carrier S2 front brake disk, Girling 60 caliper, 20mm adapter and 8J ET48 A8 wheel. Fwd C4 A6 hubs with C4 A6 brake disks for rear.

[_ShurikeN]

V6/S2 hub carrier with 82mm bearing and C4 2.0 fwd outer CV joint.

Does this CV fit bolt-on small Audi 80/90/coupe 2.3 front CV-shaft?

[mdz]

Yes, 30 inner splines, same as 1.6/2.0/2.3 shaft and 38 outer splines, same as C4q rear hub.

[_ShurikeN]

Great info, thanks, mate!

[vag_nutter]

Or machined C3/C4 quattro rears on the front

C3q rear, C4q rear, B4 front:

What are the part numbers on those hubs? I pressed out a rear hub from a 200tq and it doesn't have the same offset as the one in your pic

[mdz]

Sorry I don't have them anymore. I borrowed them for measurements and returned back.

[vag_nutter]

Maybe the c3 hub is from a widebody, ill press out a c4 hub and check with that

[sergio]

Quattro swap

i fitted a complete back end from my A4 Quattro to my B4 saloon Quattro no problems with S2 front hubs and V6 front CV`s

will find my build thread for you

Can you update and place the link for the build thread?
Can´t seem to find it