Wtd:exhaust

[blues n 2s]

as above need rear &centre section for 3b engine in 1990 20vcq.Cheers in advance

[blues n 2s]

Anybody??? oem preferred

[K Simmonds]

The OEM 3B front exhaust section will not fit a B3/4 CQ chassis due to the width of the twin pipe section where the cat's or by-pass pipes are to be found. The 3B floor has a bulge to accommodate this width.

Back box wise the 3B one is a straight fit to the CQ

As is the centre box, however ideally you need to ditch the Y section at the base of the down pipe and go single 2.75" from there to the middle box.

[blues n 2s]

The OEM 3B front exhaust section will not fit a B3/4 CQ chassis due to the width of the twin pipe section where the cat's or by-pass pipes are to be found. The 3B floor has a bulge to accommodate this width.

Back box wise the 3B one is a straight fit to the CQ

As is the centre box, however ideally you need to ditch the Y section at the base of the down pipe and go single 2.75" from there to the middle box.

i have done however both boxes have been blowing, v slightly,for a while but rubber hangers snapped on bloomin speed bumps now has large hole courtesy of driveshaft & distance from home

[K Simmonds]

Ah, I see your problem.

Someone must a have a standard back box knocking about, think an ABY one would also do.

[Acidburn]

there is a brand new back box on ebay currently.

[Paulgo]

I've got a 3B mid section and back box up in the loft that I took off when I put the Miltek on

[blues n 2s]

I've got a 3B mid section and back box up in the loft that I took off when I put the Miltek on

Pm'd mate

[blues n 2s]

there is a brand new back box on ebay currently.

Cheers mate