I've got a couple more pics, but they're not very good quality unfortunately.
The pillar trim and the aluminium channel are rivetted to the pillar upright.
You can access the rivets through holes in the channel behind the door seal:

You need to drill those rivets out, then provided the trim hasn't been bonded to the upright and channel with screen adhesive like mine was
, you need to slide the pillar trim about 10-15mm down the pillar and it pops off.
Its held on by these clips:

If you are really unlucky, you will need to spend 5 hours per side with a craft knife carefully cutting the adhesive so you can get the pillar trim off without bending it (aluminium again, be careful)
Heres a pic of the pillar upright:

Just looking at these pics brings back bad memories lol.
HTH
The pillar trim and the aluminium channel are rivetted to the pillar upright.
You can access the rivets through holes in the channel behind the door seal:

You need to drill those rivets out, then provided the trim hasn't been bonded to the upright and channel with screen adhesive like mine was
, you need to slide the pillar trim about 10-15mm down the pillar and it pops off.Its held on by these clips:

If you are really unlucky, you will need to spend 5 hours per side with a craft knife carefully cutting the adhesive so you can get the pillar trim off without bending it (aluminium again, be careful)
Heres a pic of the pillar upright:

Just looking at these pics brings back bad memories lol.
HTH
i forgot this was about the avant
Comment