Advice for plasma's dials.

[fyans1974]

Advice for plasma's dials.

Hello, i will try that, but the reason i was asking for a description was i'm not sure if i put them in the right place. I mean i have 2 black wires and 2 red wires, so i thought on the back of the heater unit i noticed on the wires at the back 2 of the brown wires had a red strip and black strip so i hooked them to that, Any help and advice will be usefull and give me piece of mind. Thanks Steve.

[s2_bo]

What you should do is remove the 3 knobs that control the heater blower fans, then remove the screws and take of the cover off.
Then poke the wires from the two inverters from behind the dash through a hole, (you may have to cut the a little grove in to the heater blower cover somewhere to make it fit flush again..)
Once you have your 4 wires, twist the two red ones together and do the same with the black ones, then pock them in to the back of one of the bulb holsters, try the lights and if the gauges light up you have them the right way round, if not swap red>black and try again.....
Refit, job one..

HTH..
Good luck.

[fyans1974]

Advice for plasma's dials.

Cheers Bo, i'll give that a go and let you know how i get on.

Thanks Steve.