Right click remote prob.

[Gazmitchell]

Hi all just after a bit of help, bought a right click remote system for my coupe fitted yesterday following guide on audifans , I've got power earth hazards but nothing re doors. ? I've spliced into the brown/grey and brown/ green as per the guide, in drivers door loom to actuator also I've put a 180 ohm resistor inline on the white/ black wire but no joy. ? Anyone throw any light on it ..?
Just wondered if better to go from the pump in rear as per other guides.....

[Bowie69]

I think you need to set dipswitches or something, is that right? 2 years sinc eI fitted mine, in the manner you describe.

[Gazmitchell]

Thanks mate. So you went from open /close wires in the drivers door rather than from pump ? I've set the pulse pins to what fitting guide said but I'll try changing it see if it does anything..

[Bowie69]

Yeah exactly. I picked up on where the original Audi-fit B3 alarm/immobiliser went in, the wires had already been extended to make is easy

I do remember being perplexed by the wiring diagram, started doing it, then realised I had the wrong one in front of me!

[Gazmitchell]

Ah ok. Sorted anyhows, was the crap cheap splice connectors from kit not connected wires in drivers door , removed em , and soldered wires , all good. Remote central locking !!