Flow rates and gasket 3A engine

[T2Andy]

Does any one know the flow of a kv engine injector and a 3A engine injector also
does anyone know the part nos.Reason for asking my mate has just bought a 3A
engine built by GTI engineering,its a 2.5 with big valves and flowed head and balanced
steel crank,this is going into his 2.3 coupe 91 .Just wondered which would be the larger injector.of the 2 .Also wanting a gasket set for the same.
This engine was in a coupe quattro 1987.

[Jas11n]

Isn't the 3A a four pot Andy? good going to get 2.5 litres.
Which gasket set? head? rocker etc.

[T2Andy]

It is A 5 pot 3A was stamped on the block it is very much like the KV .The gaskets are
head sump and rocker.:

[Jas11n]

Hmmmm, strange this. Looking in FA for part numbers for injectors, gaskets etc for 3A, says it's defo a four pot.
Autodata coming up with the same. 3A = four cylinder 2.0 litre

[volcano rs]

Hmmmm, strange this. Looking in FA for part numbers for injectors, gaskets etc for 3A, says it's defo a four pot.
Autodata coming up with the same. 3A = four cylinder 2.0 litre

if i remember rightly my audi 80 quattro 1990 had this code and it was a 4 cylinder .it has been a while and i can't remember for deffo .

[T2Andy]

Not sure then ,i know its a five pot just took the head of it it came out of a coupe quattro .

[T2Andy]

sorry for the confiusion the 2.5 is a KV and the old unit is an NG but they have 3a and 4b
on the block.