Hello friends, in these days I will completely refurb my S2 Coupe ABY LHD, I have a problem with the led of the right switch for front right passengers window, I have put another switch, led worked for some minutes and then already off, I have also change the led with a new one and already the same problem.
What do you think?
Thanks a lot!
Bye
Alessio
Audi Coupe OEM+ Interior Lighting Guide
Collapse
This is a sticky topic.
X
X
-
always wondered where can you get the interior light switch and the funk switch or any other extra switches... need to fill the blanks
Leave a comment:
-
-



Nice to see you haven't lost your touch while I've been absent Si
Leave a comment:
-
-
the FUNK switch should be used to mechanically open the exhaust right after the cats
Leave a comment:
-
It's obvious dude, always connect the FUNK to funky
Otherwise your car will end up in ashes to ashes and you'll be strung out in heaven's high, hitting an all-time low
Major Tom told me that and we know Major Tom's a junkie
Cheers n
SiLast edited by HPmuirt; 30 March 2010, 16:14.Leave a comment:
-
Im good thanks, on ma easter hols from uni at the mo. Been messing with exhaust systems, wheels and bumpers on my car lol.
Here you go:
http://cgi.ebay.co.uk/Electronic-Scr...item35a83b4adeLeave a comment:
-
Hello Jim, how's you?
Yeah, that's been mentioned before, but I don't have a switchable map and don't really intend on getting one mate.
Possibly going to link it via a relay to my switched feed on the headunit. Press the funk switch for the tunes instead of being linked to the ignition.
That or link it to a neon sign in the rear window, that tells the neds in their Corsets to nob off
Leave a comment:
-
Eh up jason, congrats on the news of a little on on the way.
Could you use that button for a switchable map i.e. sports mode?Leave a comment:
-
Haven't been around to add this one.
Interior light switch button now fitted and working great.
Revised schematic first. The permanent 12v is so that the switch works at all times, either with ignition on or off. The switched 12v is so that the switch icon is illuminated like all the others next to it.

The relay is a five pin 30 amp relay I got off ebay with a connector and some flying leads.
The connector for the switch was new from Audi along with the pins and wires.
8L0 971 972 for the connector at approx £3 and 000 979 135 for the wires with pins at approx £2 for two of them which have a pin on either end, so you just cut them in half.
Permanent 12v I took from a previously installed power socket that I'd wired into the passenger footwell.
Switched 12v was taken from the switched 12v wire I'd previously wired in to my Becker headunit, it ultimately comes from the rear of the lights on warning buzzer under the drivers parcel shelf.
All the earth's went to the earth post that is near the bonnet release lever, just joined them together into a ring tag and fixed it there.
That left one wire to run along the inner cill trim and up the door post to the door switch.
There's two wires that attach to the door switch, a brown/yellow and a brown/white. The retaining screw that attaches the door switch to the body acts as an earth. Attach the wire coming from pin 87 of the relay to the brown/white wire, I opted to snip off it's crimped terminal, join the two wires and then crimp on a new terminal.
That's it. Now the switch when used just earth's out the brown/white wire, the same as the door switch does when you open your door.
All the interior lights come on at once.













So? what shall I link this up to then?
Leave a comment:



Leave a comment: