How-To: Install Koni's and H&R's. [Pictorial]

Collapse
This is a sticky topic.
X
X
 
  • Time
  • Show
Clear All
new posts
  • montyrs2
    S2Forum Maniac
    • May 2008
    • 522
    • Country: United Kingdom

    #31
    Cheers for that. Looks like I will be picking your brains about brakes at some point in the future.

    I have a cap off the struts so hoping to get stuff to make a tool this weekend but if I don't have any luck I would be grateful if you could lend me the tool.

    Monty

    Comment

    • montyrs2
      S2Forum Maniac
      • May 2008
      • 522
      • Country: United Kingdom

      #32
      Does anyone know if you can get the plastic washers? or if they are important. I have 1 out of 4!

      Are they even important? Notice that on the parts list there isn't an oem one?

      Failing that I could make one out of ally or plastic using a hole saw.

      Comment

      • quattrostyle
        S2Forum Zealot
        • Oct 2006
        • 6229
        • Country: Netherlands

        #33
        I did not know the need for them in the previous page and still don't know. I wouldn't bother

        Comment

        • Rusty
          Super Moderator
          • Jun 2004
          • 18953
          • Country: United Kingdom

          #34
          My shocks are 0.5 from fully hard front, 0.25 from fully hard rear
          Cheers'en, AndyC
          1994 ABY Coupe - Projekt Alpinweiss

          Comment

          • k.alle
            S2Forum Maniac
            • Feb 2008
            • 801
            • Country: Sweden

            #35
            Sorry for my inactivity here. I seem to not get notifications on this topic, I'll resubscribe to the thread.
            Audi S2 -1994 | 480 Hp 650 Nm | FlexFuel | MaxxECU | 3" Stainless | Porsche GT3 Front Brakes
            http://www.garaget.org/?car=52877

            Comment

            Working...