Announcement

Collapse
No announcement yet.

RS2 Spec PRJ ABY boost issues

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • RS2 Spec PRJ ABY boost issues


    having a issue with the s2. Took it out today after about a week and it will spool and boost to 1.8bar but it hits a limit at 5k and just doesnt rev past that. Instead it pops and splutters it doesnt feel like a boost cut though, Just feels like its bouncing off the redline limiter.
    It was perfectly fine a week ago other than the slight misfire at idle.
    What could this be ?
    Specs of the setup are:
    RS2 turbo
    RS2 intercooler
    RS2 fuel pump
    RS2 injectors
    PRJ chip
    TFSI coils
    wagner EM.
    Last edited by Farhazaftab786g; 11 October 2020, 11:43.

  • #2
    Launch control becoming active due to ECU not receiving VSS signal or flatshift becoming active because of clutch switch wiring issues? Not sure what kind of chipset this is and are these features enabled in software? Pretty unlikely though if it worked week before...

    Comment


    • #3
      Originally posted by tekstil View Post
      Launch control becoming active due to ECU not receiving VSS signal or flatshift becoming active because of clutch switch wiring issues? Not sure what kind of chipset this is and are these features enabled in software? Pretty unlikely though if it worked week before...
      Launch control is enabled in the software but as far as i know flatshift is not.

      Comment

      Working...
      X