Parts required to fit Aquamist kit

[Greg_S]

Guys,

I have an aquamist kit to fit to my S2 over the winter but require a couple of bits.

I need to join the nylon supply hose to the washer bottle tank and wanted to get something I can fit to the washer bottle onto which I can connect the hose. Push fit or something along those lines.

Also I need a 1/8BSP flange/nut to mount the water jet onto, and finally a 1/8bsp nut to nipple for connecting a boost hose to sense the pressure.

Thanks in advance guys

[aelred]

You can get those parts from Aquamist

[Greg_S]

Thanks Aelred I'll give them a try again

[GazzaG60]

how you planning on mapping for the changes?

[Greg_S]

I havent just yet, the system I am fitting is the 1s which is there purely to ward off detonation. At the moment it runs very rich above 5000rpm because of the intake temps getting too high. Once I have it fitted I will see how it is performing and see about a remap again

[GazzaG60]

hope it works. know a few guys who used it on the G60's. due to the fact that they are continuously pressurising even if not on boost the cooler gets heat soaked in about 5 minutes.

its worked well for them once mapped properly but a bigger IC was always a better option.

[Greg_S]

I have a the RS2 IC already and hoping this will bring some more benefits when the boost starts to wind up above 18-20psi