Tubular manifold pics needed

[nip]

Whos running a tubular manifold on a s2? i know there a few out there, pics needed please of the setup also have you moved maf to the other side?. Cheers

[MrVain]

This is from my current S2, with www.cp-service.se manifold





This is from my old S4, same type of manifold

[terrybullwon]

Great bit of kit from Repo !

[Jonnybravo]

Still not sorted those hose clamps out yet James lol

[terrybullwon]

Haha!!!! I think they might be the same way around now James, its a old photo. Any word from your Man yet?

[Thuppu]

My first diy manifold. Don't say anything about the weldings, I know they look awful...







Oh, and I use it in my S4, so sorry, not S2.

[nip]

My first diy manifold. Don't say anything about the weldings, I know they look awful...







Oh, and I use it in my S4, so sorry, not S2.

thuppu thats a very good 1st try, its looks a hard thing to attempt

[nip]

thanks everybody, for anyone running a maf wheres the best place to relocate it, as it looks real tight to fit with tubular manifold

[DamoM]

here's a couple of pics of my wagner tubular. Had to weld a different flange onto it as it was non-audi!

[4WheelDrifter]

Keep an eye on the silicon WG signal hose Damo. They have a habit of becoming brittle with heat, then leak, and your boost goes...

[Thuppu]

thuppu thats a very good 1st try, its looks a hard thing to attempt

Thanks!

Here's another pic with the manifold installed...

[Jonnybravo]

Haha!!!! I think they might be the same way around now James, its a old photo. Any word from your Man yet?

I guessed it may ben a old picture.

I spoke with him earlier but not about the parts, I'm hoping to see him maybe this weekend or next weekend. I know I've been saying that for a while but he is a mega busy guy but I do need to get my Escort back off him so I will definitely be aiming to see him sooner than later !

[DamoM]

Keep an eye on the silicon WG signal hose Damo. They have a habit of becoming brittle with heat, then leak, and your boost goes...

you're right and thanks for the spot. I had one fail on another car. I have a roll of rubber hose at home so Will set about replacing it.

[urs4guy]

Pics.

Here are a few pics from a couple of builds by S-LIne Motorsport in Colorado who built Da Green Monstah. The first 3 are from an AAN urS6 build:







The next 5 are from an UrQ build:











Hap, wit dakine build pics not from Evahboost, Maguire