Some photos of my 93 CF UrS4

[UrS4boy]

Did this up for my home forum today so I thought I would share it here too:

93 UrS4 Emerald green pearl effect over Ecru leather and OE carbon fibre trim purchased in 1998 with:

Eibach lowering springs (1999)
Bilstein sport shocks (1999)
Big Black Porsche 928 GTS calipers on RS2 brackets with 323 x 30 A8 rotors (2011, replaced BIRA System 1 Boxster over 312 x 25s, 1999)
Refinished stock Fuchs wheels (originally came with the Speedline wheels)
Euro headlight lenses (1999)
9011 and 9012 InfraRed headlight bulbs
Frankenliner (1999 now not needed with FMIC)
Fully RS2'd AAN (MAF, injectors, exhaust cam, exhaust manifold, turbo)(2004)
Apikol FMIC (2006, replaced Marc and Tom FMIC, 2005)
Samco silicon hoses turbo to FMIC, FMIC to throttle body (2004/5)
Stock Exhaust
MRC Stage 3 software from Chips-Ur-S.com (2005 after running Uncle Bob Pingmeister, 2004)
Red V8 coilpacks (2011) on first ever(2005)1.8t coil pack harness(originally, 2005 with 1.8t coil packs)
S6 steering wheel conversion (using modified Method 1)(2007?)
CF Climate Control surround (DIY here(2008?)
Kevin D's TDS-1 System (Ver 1.0)
Modified rear fogs (both sides) to run as additional running and signal lights.

Bought but not yet installed:

Euro headlights with leveling motors
92 UrS4 rear cross member and sway bar
DEFI backlit white faced fuel pressure and boost gauges
LS2 coils
V8 torsen rear diff
Probably something else that I have squirreled away

[prosty]

Looks really clean, not really into the wheels but otherwise really nice

[macspring]

Dave,

Very tidy. Why no wheel caps ?

Any engine photos ?

Keep up the good work on this forum, it is very much appreciated.

Kind regards.

[K7ERG]

Nice.

[K7ERG]

A nice set of S8 Avus on there would look good.

[s2_wot]

Looks good without the caps IMO

[UrS4boy]

Thanks to all who have commented. I didn't check the hyperlinks I put in until late last night when I found they were borked. I fixed them and they should work now.

Re: center caps. I don't like the OE caps on the Fuchs. However, I *would* install a small OOOO cap in the small center hole IF I knew of one that worked. Anybody done this?

[mcandmar]

Very tidy motor, same colour combo as my avant

Personally i would put the center caps back on, looks "unfinished" without it IMO. Euro bumpers would be a nice addition too

[Audicted]

Looking good Dave. I have a spare blanking plate for the center dash switches if you need one.

[UrS4boy]

Looking good Dave. I have a spare blanking plate for the center dash switches if you need one.

Thanks. I have one, I need to mod it for the temporary contact switch that toggles through the TDS-1 functions (something that I have been meaning to do for like 5 years).

[prj]

So nice to see a car in completely OEM form on the visual side, but restored to perfection.

Well done.

[UrS4boy]

So nice to see a car in completely OEM form on the visual side, but restored to perfection. Well done.

Thanks. Other than the wheels, the car is not restored per se. Original paint, interior, etc. (I did redo the front suspension last year).

[prj]

I know, but it just looks very well kept and maintained. I like that.
Not a fan of the wheels myself, I think some Boleros or Avus would look much better.