Would any one be interested in one of these?

[terrybullwon]

Always be keen on running one, Just wondered if any one else would be?



Cheers James

[Jamo]

Yes I may needing one and it's one my maybe list of to buy parts. I just need confirmation it fits under the standard cambelt cover.

Other buys are takign priority at the moment as they are damn expensive!

DJones is running one on the forum.

[mcandmar]

I was thinking about getting one too, any idea on price?

[Jamo]

On ebay they are about £115

http://cgi.ebay.co.uk/Verstellbares-...QQcmdZViewItem

[CliveH]

Excuse my ignorance, but what exactly does this do for me over and above the OEM item (other than being 50% lighter)?

[Jamo]

Excuse my ignorance, but what exactly does this do for me over and above the OEM item (other than being 50% lighter)?

It's for people who need the timing needs to be adjusted on the I5 with a hall sensor.

It's of no use really to a stock setup unless you mucking about with different cams IMO

[mcandmar]

That’s not too bad, has anybody got an image of the underside?

Looking at the cam sensor ring, it looks like it’s mounted to the center part of the pulley, which isn’t going to move position when you adjust the cam timing

@Clive, it allows you to fine tune the cam timing in relation to the crank shaft. For example on an engine rebuild if you skim head/block and move them closer together it will have an effect on the relationship between the crank/cams. This jobbie basically allows you to compensate for that by having some adjustability. I'm fairly sure Jamo will need one building a stroker with a taller block.

[CliveH]

Thanks Jamo and mcandmar!

[Pisobiker]

Nice cam pulley, guys. At least it looks good.
Higly recommended to have one of those adjustable ones expecially on "Tall block" strokers ( ) 'cause the taller block causes a mismatch in the cam timing adjustment of about half a tooth...

Marco

[Jamo]

It's mounted at 5 points to the outside where the allen bolts are.

loosening the bolts and adjusting moves the hall trigger +/- degrees

[terrybullwon]

Well if theres enough interest, i will contact the seller and see if there is any movement on 10? Maybe it will just reduce the postage and bank transfers but every little helps

Also there is another company that makes a product like this, i just cant find it at the moment
IIRC Doug runs one?

[Jamo]

The above pulley is made by Dahlback and the guy must be getting stock from them somehow. They are 194 euros from Dahlback.

If you look in the centre it should say www.Audituning.com

One thing I need to know is why is there a 21 and 31 mm part?

What size is the stock OEM?

This is the only one that works with an ABY / ADU setup ( apart from Pisobikers home brew, which I hope I can get my hands on :mischeif: )

http://www.dahlbackracing.se/english/main.asp

[Jon441cc]

Well if theres enough interest, i will contact the seller and see if there is any movement on 10? Maybe it will just reduce the postage and bank transfers but every little helps

Also there is another company that makes a product like this, i just cant find it at the moment
IIRC Doug runs one?

I think Doug is using one from cat cams

[Jamo]

Have cat cams finally made a hall sensor version then?

I'll have to look at project MR600 pics

[Jamo]

How did I miss that?

How much is the Cat cams version?