Aluminum MAF flange again!

[terrybullwon]

I made another two, as i was asked for one and its less waste if two are made from one block.

Slightly cheaper this time £75 posted ( one only )

[terrybullwon]

As used by S2-Bo

http://www.s2forum.com/forum/showthread.php?t=22350&page=24

[s2tommy]

Wat is this to do? Any pics with one fitted?? Cheers tom

[terrybullwon]

Its for making your own aluminum in take track, you can use solid aluminum tube rather than silicone hoses. I can also offer this with 3" tube and welded in if wanted.

[s2_bo]

I made the mistake of welding this on the inside and on the outside which ended up in restricting the maf internals form tightening up properly.
After the welds on the inside were ground back it worked ok though.


I also found that it was a pita to re-solder the 5 pins under the maf cap that have to be snipped to unscrew it from the body.

I think i fried 2 mafs and one popped a wire after a very harsh boost spike and a hose coming off.


These bodys are good though and when reassembled using sikaflex dont leak any air when under pressure.

[terrybullwon]

Bump £60

A professional solder will be as good if not better than before, Bo take it some were local and have it done for piece of mind it cost me a drink when i had it done.

[terrybullwon]

Bump