CompTurbo 4367/65 NEW!

[Jamo]

Flange spacer no wing work IMO

[djh]

how certain are you?

[europeanme]

a little of topic...would you sell the ar 0.63 housing mentioned in the first thread...

and AFAIK the turbo won't fit a t4 flange....I could be wrong..

[europeanme]

how certain are you?

check out his new toy...

[Jamo]

It won't fit your turbo wrong turbine wheel size you have stage 4

[djh]

check out his new toy...

without knowing for definate 1100 is a lot of dollar to put on a moderators opinion so i'd like to be sure....

[smiler]

Trust JAMO...
Its sad to see it sitt on the shelf...

[smiler]

It won't fit your turbo wrong turbine wheel size you have stage 4

Do you know what trim the t3 housing has?
Think its 63mm, Stage 5?

[Jamo]

Most likely on your word when you say it's just to small that would be stage 5 62mm

[smiler]

Most likely on your word when you say it's just to small that would be stage 5 62mm

Yey sounds right...

[europeanme]

It won't fit your turbo wrong turbine wheel size you have stage 4

I do.... I didn't know that...

for some reason the more I read the more nervous I get about my 0.84ar housing and having plenty of lag....

[Jamo]

I'd put a .63 on it ct are different to garret
Put a 63 and be same near enough as a ct355 of Brams

[Thuppu]

I would test it first with the .84. I had 7A ex cam and some overlap timed. It would spool earlier with a stock setup and properly mapped. Then if it feels laggy, you could try a .63 housing, machined Garrett etc...

[Jamo]

Edit got the turbine sizing wrong 58mm = stage 3 60 = stage 4 62 = stage 5 65 = p trim 67 = mq trim

[Billman]

Edit got the turbine sizing wrong 58mm = stage 3 60 = stage 4 62 = stage 5 65 = p trim 67 = mq trim

Do you found any link with all these wheel sizes?