Brembo Front Calipers (993) & RS2 Caliper brackets

[Drummer87]

So mike these a better option to go for?? Like replacement parts in future discs etc??

[madpugger]

mine are 996T and fit under 16s (Avus) with 15mm spacers.

These would be good for you Chris.

[epic]

The Movit kit is a custom bell and porsche rotor. The info will be on the forum is you search

[Drummer87]

What discs on this setup??

[epic]

I used them with no spacers and Standard 16 Mk s2 Avus Alloys but they were very close.

[robo]

With spacers they will fit. Depends what these are

With 10mm spacers also very close.

[Drummer87]

With spacers they will fit. Depends what these are

[epic]

993t with the rs2 brackets fit under 16" but 996t don't.

See this thread for information

[Drummer87]

Would yours fit under 17"??? Be tight I think.

[madpugger]

314 mm A8 or 323mm? They look the same as mine but mine has 323s...

[twenty valve]

these are the only numbers I can see on the calipers.

[Drummer87]

What's the part numbers for the calipers???

[twenty valve]

I have a pair of front calipers from a 911 3.6 Carrera (993, 1993-1997) and genuine RS2 brackets available.

Calipers are clean and in very good condition. No damage to any of the dust seals. They worked very well on my car. All pistons can be pushed back by hand easily. Also included are a set of Mintex pads which have done about 3000 miles, so also in very good condition, cost £55 new.

1. Calipers and pads £275

2. Calipers, pads, RS2 brackets and 5mm spacers £325

3. RS2 Caliper brackets alone £70

You can fit these calipers to a stock S2 using a 304mm A8 disc, or use the 5mm spacers with a 314mm A8 disc. Both options will fit under 16" Avus wheels.