S2 and UR parts

[adam g]

Parts for sale – all in GBP. Delivery not included, it will depend where you are in the world so please ask for a quote. I will deliver as cheaply as possible. Photos available on request.

S2 bits
Metal engine mount brackets that fit between block and rubber mount. 20 gbp
Turbo oil return pipe. 15 gbp - sold
Turbo oil feed pipe: 15 gbp -SOLD
Spacer between engine and gearbox. 10 gbp

UR Quattro 10valve
Down pipe £30 - includes a tapped hole for fitting of an oxygen sensor, easily plugged if not required.
Sump, rust free painted black: 15
Idle & WOT switch – 20
Steering wheel center cover – 20
Oversize pistons £50 each – only 4 available.
Engine front mount (bump stop) 25
ARP head studs for 10v – 30 (cost 110) -SOLD
Aux radiator – very rusty but no leaks – 20. - SOLD
Boot lid, coupe, blue – 15 - SOLD
Boot lid, coupe, zermatt silver – 15
Inlet manifold – 10
MAC 01 ECU – 60 - SOLD

Efi bits
High output coil: Purchased from 034 motorsport. Details can be seen on their website. £20 - SOLD
Fuel rail: Purchased from 034 efi for use on 10V engines. I have ground some material off one end to give clearance to the throttle body, something you will have to do anyway.
Brackets and seals not included. £30

Misc
Dialynx 1.5 bar (21.8 psi) wastegate spring - new. 20 gbp
Mannual boost controller – 10
Exhaust Gas temp gauge – white face with blue illumination, as new - 10

[Drummer87]

The wastegate spring good for swapping over with the standard in the s2 Aby??

It's been home fried and alot of folk say its rated 1.5 bar.

Any gain by doing this??

You got the high output coil loom forsale??

Chris

[adam g]

The spring will fit no problem, I have an identical one in my ABY. I could not say if it suitable for your set up though.

The coil has 3 short pieces of wire attached, I can identify each wire.

[tone the bone]

ur parts

hi i have only just seen your post and was wondering if you still had the 034 fuel rail,front bump mount and down pipe tony 07584474617 where abouts in the country are you aswell.cheers

[adam g]

PM sent Tony.

[andy10v]

Which high output coil is it? For stock upgrade of aftermarket setup?

[adam g]

Which high output coil is it? For stock upgrade of aftermarket setup?

Its this coil:

http://www.034motorsport.com/ignition-solutions-034-high-output-dis-coil-p-39.html

I used it on my old 10v with a distributor and efi. I dont see why it cant be used on a Kjet system but wouldnt like to say for sure. The guys at 034 could confirm I imagine.

[adam g]

still lots left

[daren]

Interested in the s2 turbo oil return pipe, how much to post to Winchester? Cheers Daren

[adam g]

Sorry Daren, that has sold, I overlooked in the the ad update.

[drego786]

can you post me some pics and dimensions of the
Oversize pistons £50 each – only 4 available.

[Skull]

PM sent