Any interest in refubished aan engine?

[pasbogdan]

Time to sell any of my 20vt aan engines.
Complete with ecu and loom.
Can provide engine block bored and honed to 81.5 mm with new fcp pistons only aan rods or if interest could build with any type of rods.
Or engine block just checked for roundness slightly honed to refresh honing marks for oiling with stock pistons and new kolbenschmidt rings.Again rods at choice,stock or upgrade.Do not have them but i can purchase if interested.
New bearings,kolbenschmidt.Sputter for rods.
Crankshaft standard dimension journals.Checked for roundness,grinded for front and rear seals places to avoid any oil leaks.AAN cranks available or any 2.3 NA cranks with 2 lubricating ports on each bigend.
Oil pumps opened and checked for wear.New if interest.
All engine blocks face milled and note how much material removed to use info at CR.If you wish can find out CR with liquid method.
All engine blocks bearing line checked for roundness and roundness reworked if high torque bolts are used.Do not have them but can purchase if interested.ARP.
New crank sproket.New pulley bolt.
Cylinder head fully rebuild(guides,seals,valves,valve seat reworking,face milled,new tappets)Checked for leaks.NOT ported.All heads have little cracks near spark plugs,not deep.Like almost all 20vt heads.Can work this way for moderate powers,can be repaired or 7a head can be machined to fit.New victor reintz stock head bolts.If needed arp can be purchased.
New water plug with seal(rear of engine block to heater radiator)
New thermostat case with ring.
New rs2 china exhaust manifold.Nice worked,can not guarantee anything about its future life as you know.
K24 7400 turbo,new compressor wheel balanced,no play.
Rs2 injectors.
New victor reintz compleete engine gasket set.
For generic soft for k24 7400 i think Dmitri will be your man.Or someone else as you wish.
I have no clutch for sale.
All engines/setups dismantled.All repair parts that will be used are new in boxes.

Please pm for any type of setup you want.I can sell only bottom engine fresh rebuild if you wish.
Just 1 setup to make/sell.
I can find very reasonable prices for shipping

Thank you,

[pasbogdan]

k24 7400,injectors,manifold gone.

[bartolomeus]

Check your PM.

[Rusty]

Can you put some prices up please.

Interested in the AAN engine cost with upgraded rods.

[pasbogdan]

Something like 2800-3000 eur without arp head and main bolts to 4000-4500 eur with arp's,stronger valve springs,retainers,new lifters, with engine assembled fully painted with temp resistant and/or wrinkle paint.Only need coil conversion,exhaust manifold,turbo/pipes+mapping
And exhaust and,clutch and more.
OMG,is it expensive or cheap to own this type of new tuned engine?What 2.7 users deal with?