3" Stainless Downpipe ABY

[Trist28]

Brand new never fitted, was a group buy a while back. Has twin lambda holes. £250 posted to UK address. Also open to offers.

[Trist28]

Bump...

[RustyNut]

Hi Trist. What is the spec on this? What stainless is it and what flange? I'm going Rs2 with Wagner Evo, will it fit? If it does I may be interested.

Cheers.

R.

[Trist28]

Hi mate

It has stock flanges on, grade of metal I'm not sure ill see if I can find the group buy thread.

[RustyNut]

I see there were a fair few bought from the GB. Any feedback from those that bought one of these and fitted it? I assume whoever fabricates the rest of the exhaust will need to mod the DP in some way to get it to fit properly? I'm particularly interested in feedback from anyone with an RS2 turbo mated to a Wagner EVO EM?

Cheers

[John B]

3" Dp

Hi mate

It has stock flanges on, grade of metal I'm not sure ill see if I can find the group buy thread.

Hi

If this was the same as this Group Buy http://www.s2forum.com/forum/showthr...6&highlight=DP (I bought Ken's last year), then the quality was very good. The material was T304 SS except for the top section that was T321 IIRC.

Other posts on the same thread revealed that in order to fit this, ~10mm of additional material had to be added before the bottom bend had in order to route the pipe around the drive shaft heat shield.

After reading a good report by Jamo on his system by Pipewerx, I had my DP adapted as per the above by them and mated to a full T304 3" with sports cat. Sounds the business.

HTH GLWS

JB

[John B]

BTW flange was stock K24/26, with stock position for wastegate pipe. Most DPs had single lambda hole. This one seems to have to optional second hole.

Cheers

JB

[Trist28]

Sold Sold

[RustyNut]

Bought Bought!

[S2 EDS]

3" pipe needed

Can anyone help?

I am on the hunt for one of these previously bought by members.

[/QUOTE]

[RustyNut]

I personally wouldn't bother. I bought one and basically it didn't fit and was completely the wrong shape. Spend some more of your hard earned and get one made along with the rest of the exhaust. I just wish I had the same advice before I bought mine.

[S2 EDS]

Ok. Some of the reviews folks said fitted and some needed fettling.

Cheers for the advice.

Back to drawing board.

[rynaqui]

Pretty sure it doesn't look like it bends the right way, would most likely fowl the subframe..

[S2 EDS]

Pretty sure it doesn't look like it bends the right way, would most likely fowl the subframe..

[rynaqui]

Speak to Hank @ IROZ in the US if you just want a downpipe, he has the old JIG off of 034 apparently and adjusted it so that it would properly fit our B3/B4 models, does look good but cannot comment for certain if it is a direct fit. Was about 475 USD + Shipping