Hi guys
I have two set (cam gear and pin) of steel cam gear for the crank shaft on 3B, ABY, AAN and ADU engines.
It is replica of DAHLBACK CAM but cheaper ( DAHLBACK cost 271 euro) and better when you verify steel hardness.
Steel specification: 40HM + after bath with acid of nickel anodised phosphorous.
. Hardness: 57HRC
Price is 110 --> 90GBP
My car - 500HP+ ride on this and I don't have any problem , as before, with sheared pin ..


Cheers
I have two set (cam gear and pin) of steel cam gear for the crank shaft on 3B, ABY, AAN and ADU engines.
It is replica of DAHLBACK CAM but cheaper ( DAHLBACK cost 271 euro) and better when you verify steel hardness.
Steel specification: 40HM + after bath with acid of nickel anodised phosphorous.
. Hardness: 57HRCPrice is 110 --> 90GBP
My car - 500HP+ ride on this and I don't have any problem , as before, with sheared pin ..
Cheers
<==

Comment