Complete setup taken off from LHD audi S4 C4.
Info about brackets for fitting this to other chassies can be found here: http://www.s2forum.com/forum/showthread.php?t=45098
I'll dig out wiring diagram but it's about connecting 3 wires to your car and 2 ground wires.
Red/black - to brake switch
Black/blue - S20 5A fuse (didn't follow further, maybe +12v with ignition on)
White/blue - http://forums.quattroworld.com/s4s6/msgs/238784.phtml
Switch was opened and connections checked. Also brake/clutch switches tested.
Vacuum pump tested with 12v battery - working.
Vacuum actuator diafragm in one piece and working.
Someone asked how this fits into RHD car.
Let's say pedal cluster is starting point. From it you have:
- 2 ground wires after 40 inches, needs to be extented to whatever good grounding point you decide
- ECU after 100 inches, can put whereever you like - under rear seat, under the dash...
- Pump after 80 inches. Engine bay, if you don't want to extend vacuum pipes.
- White/blue wire - 80 inches, long enough to connect to the same color wire in B3/B4 black under-dash connector.
- Red/black wire - goes to brake light switch in pedal cluster
- Black/blue wire - 80 inches, connected to switched power under fusebox.
So, the only concern could be 1 rubber pipe that may need to be longer.
Stalk switch = 443 953 513 J
But it's not a problem to transplant cruise lever to different center diameter switch.
Weight: 1700 grams + packaging
Shipping to UK would cost 10 gbp
Info about brackets for fitting this to other chassies can be found here: http://www.s2forum.com/forum/showthread.php?t=45098
I'll dig out wiring diagram but it's about connecting 3 wires to your car and 2 ground wires.
Red/black - to brake switch
Black/blue - S20 5A fuse (didn't follow further, maybe +12v with ignition on)
White/blue - http://forums.quattroworld.com/s4s6/msgs/238784.phtml
Switch was opened and connections checked. Also brake/clutch switches tested.
Vacuum pump tested with 12v battery - working.
Vacuum actuator diafragm in one piece and working.
Someone asked how this fits into RHD car.
Let's say pedal cluster is starting point. From it you have:
- 2 ground wires after 40 inches, needs to be extented to whatever good grounding point you decide
- ECU after 100 inches, can put whereever you like - under rear seat, under the dash...
- Pump after 80 inches. Engine bay, if you don't want to extend vacuum pipes.
- White/blue wire - 80 inches, long enough to connect to the same color wire in B3/B4 black under-dash connector.
- Red/black wire - goes to brake light switch in pedal cluster
- Black/blue wire - 80 inches, connected to switched power under fusebox.
So, the only concern could be 1 rubber pipe that may need to be longer.
Stalk switch = 443 953 513 J
But it's not a problem to transplant cruise lever to different center diameter switch.
Weight: 1700 grams + packaging
Shipping to UK would cost 10 gbp
Comment