ABY 6 speed Front Gear Linkage Bush

[irishs2]

Thanks for the interest guys

All pms send / replied

[PRY4SNO]

Paid

Thanks Eric!

[irishs2]

[valjo]

i want one set too

[Greg_S]

Do you have fitting details too?

[irishs2]

You dont need to fully remove the arm, just undo the 10mm nut and pull that assy from the gearbox. I do this when I bleed the clutch. Its not a hard task. Then pull out the plastic bushes and replace with the nylon ones and refit.

[Greg_S]

Thanks, I wasn't sure how much of a pain it would be

[irishs2]

This is how they look after they come out of the printer. The 100micron brim is there to for purge and hold the bush in place while its being printed.

They take 33min each to print in 100micron layers. Thats 66mins per set. I do them in singles to maintain roundness because if you do them in pairs or more , the print head goes from bush to bush and there is drag/bridging between the bushes.



This batch


And attached is an image of the first lot being posted.

[Thuppu]

Nice

[A1QSHIP]

Payment sent.
Thanks Eric.

[K Simmonds]

At least one set for me please Eric, one for your old car and I expect Charlie would like a set.

Will PM in the morning...

[K Simmonds]

[QUOTE=irishs2;912806I only listed 6 speed as I am only able to test on the aby. From the part numbers of the relevant linkage , it does look to be common among older cars. I would think the 5 speed are very similar or exactly the same bush.[/QUOTE]


I can also check this for you.

[ThatGUY]

PM sent

[IvillhaS2]

I will take a set shipped to Norway!

[90quattrocoupe]

Paid.

Greg W.