Rh zw1 - 8x17 split rims with tyres

[gavs20v]

Set of 4x 5x112

Rh zw1 8x17 et60 ( I think but can check ) 2-piece split rims.

Excellent condition with 4x near new nankang ns2 ( less than 500 miles )

Located in Chorley lancs howeve maybe be able to deliver between there and Kent

£550

Gav

[vonbeck]

you know we like pictures

[gavs20v]

I'll try and grab some

[AndyD]

Pics uploaded on behalf of Gav, all 4 wheels are the same however 2 are still on the car, so couldnt get at them to take pics....

[gavs20v]

Cheers Bro

[freakytate]

are they staggered or square? are the two in pics fronts or rears if staggered

[gavs20v]

They are not staggered . 8x17 on all four . Wider lips are readily available through felgenfuch' and radinox
Gav

[gavs20v]

Bumpy

[gavs20v]

Up we go

[cardcrash]

What size tyres are on these, I can't quite make it out 225/235 40? R17? ...and can't see the speed and load rating?

[gavs20v]

Morning ,
They are 205/40x17 with the higher speed rating

[cardcrash]

205/40!?! Little narrow and low sidewalled for 8" wheels?? I'm after a set of wheels good for 235's. Also are these dished enough so the centre section/spokes aren't proud of the rims as they are on the standard RS2 wheels, I'm always paranoid of crunching them against a curb!! :/

[gavs20v]

There is a slight stretch but it's minimal as can be seen in the above pics.
The outer dish sits proud of the centre by quite a way

Gav

[cardcrash]

You say they're ET60, my standards are ET55, I'm guessing this is to offset the dishing effect.

[gavs20v]

They have such a high et from the factory to allow for adapters to be used ( ie to 5x100 , 4x108 etc .

A 5mm spacer will bring the et down to 55