Abz flywheel

[sam80quattro]

Bought abz engine and gearbox a while back and this flywheel was bolted to it with a 228mm clutch but seen as though I plan to turbo my abz I'm after a 240mm clutch




£250 +post
Located in newcastle

[bluequattro]

What gearbox was on it?

[Kieron20V]

Have you already got a 240mm flywheel to replace it? They're like rocking horse poo, I'd say stick with what you've got and run an uodrated vr6 clutch, there must be plenty of options out there for big power vr6 turbos that should be up to the job. Will be easier and cheaper in my opinion if you don't have anything to replace it already that is.

[sam80quattro]

Vr6 plates don't fit, been there and tried it unfortunately.
The project wnot be happening anytime soon so not a major concern at the minute lol
Thanks though.

It was a 5 speed b3 coupe quattro gearbox. I've never actually ran it though..

[Grillage]

Is there a 60-2 tone ring on the flywheel?

[sam80quattro]

No sorry

[Kieron20V]

Vr6 plates don't fit, been there and tried it unfortunately.
The project wnot be happening anytime soon so not a major concern at the minute lol
Thanks though.

It was a 5 speed b3 coupe quattro gearbox. I've never actually ran it though..

What's the flywheel designed for then? Does a 1.8T pressure plate bolt up?

[sam80quattro]

In assuming it's a one off for an abz and yes a 1.8t pressure plate bolts up perfectly

[sam80quattro]

Kieron the vr6 plate doesn't fit b3 80/90 gearbox splines ... Just to clear that up