Gold plated MAF connecctor terminals

[veneto rs2]

Hey Stefano!

You can use a JPT 6 way connector, but it's not just the same as the OEM unit.




I can't find a source for the original AMP units with the pink inserts - I think they are obsolete as the new style power timer connectors are used on everything now:

I believe i'm not the only one....
When you collect parts for ages and then you forget about it...
Had an AAN motor loom seating in a box for years and sure enough with two of these plugs seating there.

Job done.

Thanks again Alex

[domas]

are those difficult to swap? i mean terminals on oem connector housing some terminals are more difficult than others to pull out. this one is big it should not be a problem. There is no pink locker like in new units right?

i am asking as my connector tools i have ordered are likely arriving later than the terminals from Error404, but i guess i can use a single small screwdriver to unlock a tab at a time, right? or i really cant avoid 2 small screwdrivers?

[Error404]

These are easy
You only need to push down one tab on the terminal because when you pull out the pink insert, you can pull back the retainer on one side.

HTH

[domas]

Okay thanks for letting me know
cant wait for it to arrive as i am so tired of MAF signal too low code - also slightly low on power. Hope it will solve it.

[domas]

item received, thanks Error!
will have to check if the crimper I have is good enough

[BLAMM0]

Received also, thank you.

[vonbeck]

Pm`d

[BLAMM0]

Ok, so how to remove them without harming this housing?

I see that you need to push two pins down and pull, just not sure what tool to use.

[Error404]

It's really easy
I will post some pics tomorrow evening

[BLAMM0]

Any news on the instructions? thanks