Wtd: Avant rear ABS sensor

[mcandmar]

Anybody got one spare, give me a shout.

Cheers,

Mark

[Christophski]

This afternoon I may be able to come up with a solution for you. I will post back later.

[Christophski]

Right, I can safely tell you that I have found a source of brand new ones. Picked two up today for me so still need to fit them. They are identical in every way apart from they have a square plug on the end instead of a round one.

I found an old thread where Alex (error) says these can be spliced in with no issues.

The ones I found are pn 8d0927807c or beckermann pn 805-0209 and cost me £13. I found these by cross referencing the og pn and finding the same pn brings up the abs sensors for an early a4.

I hope this helps bud

[mcandmar]

That part number brings up loads of options on eBay, guess i'll buy a new one for that kind of money. Cheers Chris

[Christophski]

No worries. Thought it would help and yes for that money it's worth getting new. Any moto factors can get it with that pn. Glad it helps

[mcandmar]

Got this fitted tonight, was a nightmare getting the old one out, but the new one works perfectly. Only thing wrong with it is the different rubber grommets but i found you can take the electrical plug off the terminals and slide all the rubber bits off the old loom and transfer them to the new one.

Cheers mate

[Christophski]

Yeh I took the plug off to swap the round styled one onto it and whilst it was off I moved the rubbers around so they fitted in the correct places.... Still to work out if mine has done the job. Glad it worked ok for you

[mcandmar]

Curious, the elecy plug was identical on mine being the rectangular 2 pin, maybe its different on a coupe? I discovered on my way to work the ABS sometimes triggers as the car is about to stop, usually in traffic where you are lightly braking. I suspect i just need to close the gap a little between the sensor and ring as i only guesstimated it last night.

[Christophski]

Mine has a round plug. I hope mine are far in enough. Let me know how you get on.

[betterwith4]

Im sure most of the abs sensors are generic through the audi range :s so I was told anyways Im Sure someone would either prove me right or wrong haha

[mcandmar]

Mine has a round plug. I hope mine are far in enough. Let me know how you get on.

Closed the gap another mm and its been working fine, sorted

[Christophski]

Good glad it worked buddy.

[Tom_]

Any advice which abs sensors will fit directly on CQ20V? I need a 2 rear and 2 front ABS sensors, OEM numbers are 893 927 803 or 893 927 803 A for the front and 893 927 807 C or E for the rear. What number is correct for 7A Coupe Quattro?ETKa does not show wich number is for which engine. Should i use a different OEM number of sensor, for others vehicle?

So 8D0927807C for the rear, with cut off a connector and use old one?
Or use 2 pieces 4A0 927 803 for the rear?Looks the same as Old ones...same connector...Maybe it works 4 pieces for rear and front too?