After much faffing about with different chip sets I've decided to stick with my Hoffer software until I convert the car to coil packs and install a K26/7, have MTM software at the ready and most the other parts required, just need a turbo and some wiring.
These are a nice safe chip set, run's 1.8 bar peak and 1.4/5 bar at the red line, very smooth and progressive, however I prefer the savage software so these are surplus to requirements.
You'll require.
RS2 Turbo.
RS2 EM
RS2 Injectors.
7A 4 Bar FPR.
3 Bar MAP sensor.
Optional but beneficial in order of priority.
Uprated fuel pump, ie 040 or 044 etc.
3" down pipe,
RS2 Intercooler.
RS2 Airbox.
It's essential that the ignition system is in tip top condition and the dissy has the correct narrow rotor arm! So unless you know how old your HT leads are buy new ones!
£145 posted to a UK address, will post worldwide also.
These are a nice safe chip set, run's 1.8 bar peak and 1.4/5 bar at the red line, very smooth and progressive, however I prefer the savage software so these are surplus to requirements.
You'll require.
RS2 Turbo.
RS2 EM
RS2 Injectors.
7A 4 Bar FPR.
3 Bar MAP sensor.
Optional but beneficial in order of priority.
Uprated fuel pump, ie 040 or 044 etc.
3" down pipe,
RS2 Intercooler.
RS2 Airbox.
It's essential that the ignition system is in tip top condition and the dissy has the correct narrow rotor arm! So unless you know how old your HT leads are buy new ones!
£145 posted to a UK address, will post worldwide also.
Comment