4x108 rear brake upgrade (quattro)

[Ilkorin]

A full rear brake kit as detailed in the thread below:

http://www.s2forum.com/forum/showthread.php?t=74113

2x citroen berlingo discs, machined center bore and stud holes. Ready to fit

2x URS4 calipers painted in blue with carriers

and now my tale of woe.... These don't fit a cabrio (and presumably any FWD car - but I haven't checked this) because of the unique rear end hub spacing. Discs fit nicely on the hub, but the calipers don't line up.

So in short - 4x108 quattro only, but yours for £120 posted (or will do £100 collected around grays/basildon)

[goodazz]

and only a coupe quattro or b3 sedan quattro.
not b4 avant/sedan quattro

[quattro-nick]

I designed this setup
did you also use some custom washers from 6mm thick?
you need to put the washers between the caliper and the wishbone

[Ilkorin]

Good info! Nope, I haven't got these washers - the problem is I collected these bits then on the first test fit I found out that they are just nowhere near right for a cabrio rear end so decided not to bother with the conversion (I think for the cabby it would need 50-60mm of spacing before it is anywhere near correct!) I know the discs fit (center bore) and the holes line up because I bolted the disk on, and I know the caliper carrier holes are correct, but offsets for the various cars I have no idea

So to confirm these are B4 coupe quattro / B3 coupe quattro / B3 saloon quattro only?

[Ilkorin]

And what about B2 cars? Were these completely different also?

[quattro-nick]

this setup have i made for my b2 coupe quattro car
b2 and b3 quattro are the same,b4 is different

[Ilkorin]

Close up of one of the calipers and the rough blue paint!