Dual plenum intake manifold

[grundey]

The one in the picture was from AAN

[volcano rs]

are you going to make some more?

[s2dk]

Yah i could se

[grundey]

I started a new one

[s2dk]

could it be made so i would fit a aby with out relocate the servo pump`?

[grundey]

Yes, I could make one, bet then then I need to start from beginning

[s2dk]

okay i see cant u just modify one to fit or is that to much? how much would it be if u had to make one that fittet ?

[grundey]

The runners I made are already bent to accept the head flange and pre-tacked in the manifold base.

To make it fit with power steering pump, I need to bend the runners or weld in a bend which would be the easiest way and figure out the height so that it won't hit in the bonnet.

[s2dk]

i think a lot of us would like to keep the stock pump position so its would be a lot more duable for a daily running car maybe? if the cost is at the 600-700 euro then i think it whould be a seller

[vti2]

i think a lot of us would like to keep the stock pump position so its would be a lot more duable for a daily running car maybe? if the cost is at the 600-700 euro then i think it whould be a seller

You can get a bracket from Wagner that allows you to lower the pump. It is the same bracket that comes with their IC kit.

[vti2]

Dual plenum intake manifold

I would make the TB inlet rounder and not a 90 degree inlet.

[inline560]

Damn! Those stacks!! I'd love one of these to fit a t44 200!