Garrett GT3076 hot side K26 0.82

[Spidey]

For sale my used GT3076r / GT3071r hot side with K24/K26 flange (0.82 a/r)

The housing has no cracks. Just scratches as was hard to remove..

http://imgur.com/a/eIWrj


Looking for €200

[Costash]

Do you know what size wheel can accommodate?

[Spidey]

Turbine wheel: 60mm

[Costash]

Do you know if this is a direct swap to a kkk 26/27 hot side? Thx

[Spidey]

Hmmm I'm not sure..

[K Simmonds]

Hmmm I'm not sure..

No it won't bolt straight on to a KKK center section, I have one of the same housings in stock.

[Costash]

No it won't bolt straight on to a KKK center section, I have one of the same housings in stock.

Was nice to try that if straight fit on a kkk26/27

[K Simmonds]

Yeah I wish they were interchangeable, it might fit with machine work but I'm not certain, still it's a nice housing to build a Garret up with.

[kj6304]

Hi there,
Do you think it can fit a turbine of 56.5mm/84 trim? Would be interested if it does. I have a Garrett GT3071R-WG with a housing for 1.8T. Thanks in advance. Best

[Spidey]

Sorry, but this turbo use a smaller (56.5mm) turbine wheel and comes with T25 internal wastegate housings only...

[kj6304]

Thanks for your quick reply. What I would like to know is does the hot side housing can fit a 56.5mm with a 84 trim. Will it fit to my turbo to replace the housing for 1.8T?
Much appreciated. Best.

[kj6304]

K26 hot side housing

Hi there, is me again. Your housing is for a 60mm wheel but what about 56.5? Does it matter if it's smaller if what I would like to find out and make you an offer for it.
Thanks & regards

[Spidey]

Hi,
It will fit but your wheel is smaller diameter, so this will be not good..


Damn, just checked and I had hot side housing for your turbo few months ago.. but I sold it It was K26 with turbine wheel diam 56.50mm...
He is rebuilding turbos for old Audi's as he said.. I can give his contacts so maybe he can help you He's from UK

http://www.s2forum.com/forum/showthread.php?t=80113

[kj6304]

Gt3071r

Many thanks for your information and I will try to contact him north of the border. Would you be able to find another one just like that? It is exactly for the same Audi 1994 URs4 that I am looking for the K26 hot side with 56.5mm wheels.
best and have a great weekend.

[etsola]

Hey Spidey, I never actually bought the hotside ... As it seems, it was meant for a GT30 series instead of the GT28 based on the measurements you sent in the other post (after verification on the Garett site).

Anyways, still looking for a GT28 kkk flange hotside ... if anyone reads this and has one

Also, I'm not rebuilding turbo's for old Audi's ... I'd like to ... but I don't

In the end, maybe you quoted the wrong post ?

Cheers