Audi S2 "imsa"

[G60Rallye]

Superb work again! What thickness tubing are you using for the spaceframe? I think it could end up being heavier than you think?

[Audi imsa racing]

Superb work again! What thickness tubing are you using for the spaceframe? I think it could end up being heavier than you think?

As thin as the rules allowes, the weight lands where it lands...

[Audi imsa racing]

Some pics isn`t going to hurt i think..












Just some trial fitting, I will make a jig and weld it 100%.

I have found out the basic setup for the car, so when the car is finished the research after a good track setup begins..

[s2_bo]

[Audi imsa racing]

Some pics from the construction of the suspension..

[dog_day_sunrise]

Can't wait to see how this ends up

[Rocco]

complete awesome

very good job¡¡

[Jeffer]

Thats a lot of work in there!
Looking forward to more pics!

[Audi imsa racing]

Some pics from the construction of the jig for the a-arm.

[nervas]

better not to use rod end type at the wheels side.. it always gets loose on hard braking

[Audi imsa racing]

better not to use rod end type at the wheels side.. it always gets loose on hard braking

I have seen some cars with the rod end type at the wheel side and the owners have never talked about them getting loose.. Beside it can not screw it self out completly because it will be stopped by the parts it is attached to.

[Audi imsa racing]

[Audi imsa racing]

edit: the writing on the pics says: venturi/diffusor and vents for the hot air from the rear brakes and diff.

[tsin]

do you plan imsa body kit?? (imsa replica?)

[Audi imsa racing]

do you plan imsa body kit?? (imsa replica?)

No i dont, Audi never built a S2 imsa. I just called it s2 imsa because I am building it like Audi may have built it, if they would have done it... Besides getting hold of some imsa gto molds is almost impossible, there is one guy in sweden (Anders carlson, Ace competion) he has some molds and one other guy from sweden was allowed to take some measures and make a replica, or you can take a trip to ingolstadt and make some molds from the original (but i dont think AUDI would let you do it)