RS2 Tuned by SKN Slovenija

[VU-002-RS]

some news!!
the engine is loaded in!!

[VU-002-RS]

[VU-002-RS]

[URquattroGus]

Looking good! Have you considered a reverse inlet manifold? Looks like it would work well with this setup.

[VU-002-RS]

Looking good! Have you considered a reverse inlet manifold? Looks like it would work well with this setup.

If you look before I had the intake with a shorter path, I even had ITB setap. for the sake of authenticity I decided on an original intake!
As for the throttle response I felt no difference in all three cases, regardless of the length of the tube.

[VU-002-RS]

This idea came to me recently, I am left only to connect and try out on my vehicle




means when the flap is closed the exhaust gases pass through the catalyst, and when the flap is open gases come out directly and loudly
my aim is primarily to have the option of passing on the eco test

[quattrostyle]

Well if you can find the room for it to fit it under your car...

[VU-002-RS]

by measures should replace middle exhaust muffler

[VU-002-RS]

more changes
to better respond to the throttle and the car drivability I decided on a smaller turbo!
decision has been made on the CT355 Hybrid with intake of billet Garetta GTX 30/76 good for 500 + hp!
and it looks great to me!
I like it so much that I also GTX wing put in my CT367 that I will keep for another project

[VU-002-RS]

[VU-002-RS]

RS has finally been completed, there is only ECU mapping to be made

[Greg_S]

Have you made switchable CATs for the exhaust, was trying to work that picture out?

[VU-002-RS]

Have you made switchable CATs for the exhaust, was trying to work that picture out?

yes cats can be turned off at the switch inside!

[VU-002-RS]

car is sold! This tread can be locked!

[popdemonic]

what's your next project?