My S2 project,

[audi-szwei]

Stunning scenery and roads

Btw where did you find the front lip?

Votex lip that i won on ebay

[audi-szwei]

Mr. Shiny at Oslo motorshow a few weeks ago

[quattrostyle]

Votex lip that i won on ebay

Designed for these cars or..?

[basala]

Is it "Trollstigen" on foto's ? car looks awesome. Great job!

[audi-szwei]

Designed for these cars or..?

Yes

[audi-szwei]

Is it "Trollstigen" on foto's ? car looks awesome. Great job!

Yes it is Thanks

[audi-szwei]

I have been working on the 2 door Audi 80 to give it some upgrades since last month.
Hope to have it ready when the snow disappairs. Bought a 2.0 16v ABF engine from a golf 3 gti, a 5 speed fwd transmission from a old VW passat, and a 2.0 ACE Audi engine that i will use as a donor engine for the ABF to fit in the car.

ABF engine will get a full makeover with custom camshafts, port and polish cylinder head, h-rods, custom wossner pistons, autronic sm4, trottle bodies, and much more



Compomotive 8x15



Rear coilovers



fibreglass boot spoiler



Bought two recaro seats from a s2forum member



Compomotive stripped and powder coated in white

[audi-szwei]

An old damage and bad repair with body filler

[Vorsprung durch Technik]

I've just gone through the whole thread. I'll leave my comments here with these!


If i could ask,what sealer did you use here between the wing and the lower front panel?

[audi-szwei]

Two 5 speed transmission from a 1984 vw passat



Billet crank pulley



Pistons 83,5mm



Custom front coilovers



Rear brake caliper from a golf 2 gti.



Alcon clutch





Golf gti flares



Homemade short shift




Strut bar from a b4 chassi

[audi-szwei]

I've just gone through the whole thread. I'll leave my comments here with these!


If i could ask,what sealer did you use here between the wing and the lower front

Thanks

I used a teroson 9320 seam sealer.

[geryS2]

nice project !

[quattrostyle]

Another great project those fenders look nice, would they fit a 90/coupe as well? I think not without trimming the bumper?

And I take it that's a 7A manifold that you will cut one pipe off?

[macspring]

Lovely work as per usual.

Can I ask when you decided to have it as a fwd given the annual snow etc. ? Just curious.

Looking forward to when you start on your C4q

[audi-szwei]

nice project !

Thanks